Installation - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Caution
Risk of injury by electric shock!
All electrical installations must be performed by an authorised electri-
cian!
During assembly please always ensure that cables cannot be damaged
during system operation. Any sharp edges which the cable comes into
contact with must be covered with suitable protective band. Damaged
wiring may be replaced by the manufacturer only.
If more than one drive is controlled using the VC470-II, the drives must
be decoupled by relay controls.This does not apply to Becker drives
with electronic limit switches.
The switched current of the device must be observed at all times.
Mains 230 V / 50 Hz
1= N (blue)
= earth conductor (green-yellow)
2= L1 (black)

Installation

4034 645 230 0
Tubular drive
1= N (blue)
2= black
= earth
conductor
3= brown
(green-
yellow)
Fixing lug 4x
de
en
fr
nl
21