Bosch D-tect 150 Professional Notice Originale page 24

OBJ_BUCH-844-006.book Page 24 Monday, August 30, 2010 10:44 AM
24 | English
Universal Mode (default setting)
"Universal mode" is suitable for most applica-
tions in brickwork or concrete. Plastic and metal
objects as well as electrical wiring are dis-
played. Hollow spaces in brickwork or empty
plastic pipes with a diameter of less than 2 cm
are possibly not displayed. The maximum meas-
uring depth is 6 cm.
Concrete Deep
"Concrete deep" mode is particularly suitable
for concrete applications. Reinforcing steel,
plastic and metal pipes, as well as electrical wir-
ing are displayed. The maximum measuring
depth is 15 cm.
Panel Heating
The operating mode "Panel heating" is particu-
larly suitable for detecting metal, metal-com-
posite and water-filled plastic pipes, as well as
for electrical wiring. Empty plastic pipes are not
displayed. The maximum measuring depth is
8 cm.
Drywall
The operating mode "Drywall" is suitable for
finding wooden beams, metal framing and elec-
trical wiring in drywalls (wood, gypsum board,
etc.). Filled plastic pipes and wooden beams are
displayed identically. Empty plastic pipes are
not detected. The maximum measuring depth is
6 cm.
Hollow Block
The operating mode "Hollow block" is suitable
for walls with many air pockets. Metal objects
and "live" conductors are detected. Plastic
tubes and voltage-free conductors are not de-
tected. The maximum detection depth is 6 cm.
1 609 929 X40 | (30.8.10)
Changing the Display Modes
Note: Changing the display modes is possible in
any operating mode.
To switch from the standard start display to rule
mode, press and hold selection button 10 or 12.
?
N
8.8 cm
S
20.1 cm
18 19 20 21
cm 10cm 20cm
Prev.
Concrete deep
In the example, rule mode shows the same situ-
ation as in figure D: Three steel bars equally
apart. In rule mode, the clearance between the
detected object centres can be determined.
The measuring distance covered from the start-
ing point (in the example 20.1 cm) is displayed
under the indication of the allowable drilling
depth l.
The three objects are displayed as rectangles in
the small rule above the operating-mode indica-
tion h.
Note: Both the indication of the allowable drill-
ing depth l as well as the material property m re-
fer to the object pictured black in the sensor.
To return to the standard start display, briefly
press selection button 10 or 12.
Note: Only the display is reset, not the measur-
ing mode!
22 23
30cm 40
Next
Bosch Power Tools