Declaration Of Conformity; Inserting/Replacing The Battery - Bosch D-tect 150 Professional Notice Originale

OBJ_BUCH-844-006.book Page 20 Monday, August 30, 2010 10:44 AM
20 | English

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61010-1,
EN 55022, EN 55024, EN 302435-1,
EN 302435-2 according to the provisions of the
directives 1999/5/EC, 2004/108/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 26.07.2010
Assembly

Inserting/Replacing the Battery

To open the battery lid 4, press the latch 5 in the
direction of the arrow and remove the battery
lid. Insert the batteries/rechargeable batteries.
When inserting, pay attention to the correct po-
larity according to the representation on the in-
side of the battery compartment.
The battery indicator b in the upper status line
on the display 16 indicates the charge condition
of the batteries/rechargeable batteries.
Note: Pay attention to the changing battery sym-
bol so that the batteries/rechargeable batteries
are replaced in time.
When the "Please
Please change batteries
change batteries"
warning indication is
indicated on the dis-
play 16, the settings
are saved and the
measuring tool switch-
es off automatically. Measurements are no long-
er possible. Change the batteries/rechargeable
batteries.
1 609 929 X40 | (30.8.10)
To remove the batteries/rechargeable batteries,
press on the rear end of a battery as indicated
in the figure on the battery lid ( ). The front end
of the battery/rechargeable battery is released
from the battery compartment ( ), so that the
battery/rechargeable battery can easily be re-
moved.
Always replace all batteries/rechargeable bat-
teries at the same time. Do not use different
brands or types of batteries/rechargeable bat-
teries together.
Remove the batteries/rechargeable batter-
ies from the measuring tool when not using
it for longer periods. When storing for longer
periods, the batteries/rechargeable batteries
can corrode and discharge themselves.
Operation
Protect the measuring tool against mois-
ture and direct sun light.
Do not subject the measuring tool to ex-
treme temperatures or variations in tem-
perature. In case of large variations in tem-
perature, allow the measuring tool to adjust
to the ambient temperature before switch-
ing it on. In case of extreme temperatures or
variations in temperature, the accuracy of
the measuring tool and the display indication
can be impaired.
Do not attach any stickers or name-plates
to the sensor area 9 on the back of the
measuring tool. Especially metal name-
plates affect the measuring results.
Use or operation of transmitting systems,
such as WLAN, UMTS, radar, transmitter
masts or microwaves, in the close proximity
can influence the measuring function.
Bosch Power Tools