Guard Mode - Abus TVIP41550 Manuel Utilisateur

"Enable video server tampering detection" The sensor system is activated.
"Triggering behaviour" The period defines how long a tampering event must continue before an alarm
is triggered.
The following tampering events are checked:

Camera rotation

Camera masking

Camera defocussing
You can set tampering detection as a trigger in the camera function "Application/Event setup".

13. Guard mode

You can configure the guard mode and the additional event settings here. In general, a criterion for triggering
must be configured (PIR sensor, virtual alarm input, motion detection, etc.) both for guard mode as well as for
the additional event set up. The reaction is configured using server settings (the service) and medium (the file
which is sent). A typical event appears as follows:

The set trigger detects an alarm (motion detection)

A message is sent by email (server setting)

An alarm picture is included in the email (medium)
Guard mode is comprised of the following areas:
Guard mode:
The camera features an internal sensor system (PIR detector, motion detection) as well as virtual inputs and
outputs. In guard mode, the camera can monitor both the internal sensor system as well as the virtual inputs,
and in the event of an alarm can trigger a network alarm via the virtual output. This functionality is designed
for use with an IP alarm module (CASA10010) or SecvestIP (FUAA10000).
Event set up:
If guard mode is not used, or you wish to configure additional tasks in the camera, you can configure
additional actions using the event settings.
Server settings:
The server services which have been set are listed here. Email, network storage, FTP server or SD card can
be used (SD card has already been preconfigured)
98
English