Guard Mode Settings - Abus TVIP41550 Manuel Utilisateur

Medium:
The media which have been set are listed here. Videos, pictures and log files can be set.
Virtual DI and DO:
The virtual inputs and outputs are listed here. The camera features two virtual inputs and outputs each.
The status indicates whether there is a current alarm on virtual input 1 or input 2. The inputs can only be
triggered if the PIR camera has been properly set up using IP alarm module or SecvestIP. The network path
to the respective device (on virtual output1 and output2) also defines the network device to which the virtual
inputs of the PIR camera have been assigned.
Do not change the settings for virtual output1 and virtual output2 manually, but rather use the entry
masks for SecvestIP or IP alarm module to integrate the PIR camera.

13.1 Guard mode settings

"Enable guard mode" This allows you to activate the guard mode. The camera now continually checks the
schedule, sensor selection and verification triggering conditions.
"Reactivate guard mode" You can define the delay time after an alarm in guard mode.
99
English