Connections, Operating And Display Elements; Connection Terminal - Cameo H1 FC Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1

CONNECTION TERMINAL

The connection terminal is used for voltage and signal supply for fixed installations. Observe the
safety instructions for wiring the terminal under CABLING THE TERMINAL.
2
FUSE
Fuse holder for 5 x 20 mm fuses. CAUTION: Replace the fuse only with a fuse of the same type
and value. In the event of repeated fuse failure, please contact an authorised service centre.
3
DMX IN / OUT
RJ45 network connectors for connecting to a DMX network in order to send the control signal.
Use CAT 5e, or better, cables to set up the network.
12
5
1
4
8
7
2
3
6