Storing Stations In Memory; Fm Station Automatic Preset: Ssm - JVC KD-AR300 Manuel D'instructions

3
Tune in to a station you want while
"M" (manual) is still flashing.
To tune into stations of
higher frequencies
To tune into stations of lower frequencies
• If you release your finger from the button,
the manual mode will automatically turns
off after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 200 kHz intervals for
FM and 10 kHz for AM) until you release
the button.
When an FM stereo broadcast is hard to
receive:
1
Press MODE to enter the
functions mode while listening
to an FM stereo broadcast.
2
Press MO (monaural), while
"MODE" is still flashing on the
display, so that "MONO"
appears on the display.
Each time you press the button,
the monaural mode turns on
and off alternately.
MO (monaural) indicator
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM
band (FM1, FM2, and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the
button, the band changes as
follows:
FM1 FM2
2
Press MODE to enter the functions
mode.
3
Press and hold SSM for about
2 seconds.
"SSM" flashes, then disappears when
automatic preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2, or FM3).
These stations are preset in the number buttons
—No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
FM3 AM
11