Remote Commander; Inserting Batteries - Sony TU-1041U Mode D'emploi

Location and Function of Parts and Controls

Remote Commander

MUTING DISPLAY
RGB1 RGB2
LINE
1
4
7
10/0
STILL ZOOM
POWER
SELECT
ON
OFF
ON
SET
OFF
ID MODE

Inserting batteries

Insert two size AA (R6) batteries (supplied) by matching
the + and – on the battery to the diagram inside the battery
compartment.
6
POWER
YUV
Y/C
MTS/MPX
2 3
5 6
8 9
CH
DEGAUSS
MENU
ENTER
VOL CH
}
]
]
}
1 MTS/MPX button
This button works in the same manner as the MTS
button on the tuner.
Press this button to switch the reception modes of the
tuner. Each time you press this button, the reception
mode switches in order of main, monaural, SAP, and
back to main.
When the tuner is in the stereo mode, press this button
to switch between stereo and monaural.
2 0-9 buttons
These buttons work in the same manner as the 0-9
buttons on the tuner.
Use these buttons to select a channel.
3 CH button
This button works in the same manner as the ENTER
button on the tuner.
Press this button to tune in the selected channel.
To select channel 14, for example, press 1n 4n CH.
4 CH +/– buttons
Use these buttons to scan channels.
Notes
• The buttons other than those described above function
only when other Sony equipment is connected to the
CONTROL S OUT jack on the tuner. Refer to the
operating instructions of the equipment for the button
operations.
• If a cable is connected to the CONTROL S IN jack on the
tuner, the tuner's remote commander will not work.
Notes
• Under normal conditions, batteries will last up to six
months.
If the remote commander does not operate properly, the
batteries may be worn out. When replacing batteries,
replace both of them with new ones.
• Do not mix old batteries with new ones or mix different
types of batteries together.
• If the electrolyte inside the battery should leak, wipe the
contaminated area of the battery compartment with a
cloth and replace the old batteries with new ones. To
prevent the electrolyte from leaking, remove the
batteries when you do not plan to use the remote
commander for a long period of time.
• Do not handle the remote commander roughly. Do not
drop it, step on it or let it get wet.
• Do not place the remote commander in direct sunlight,
near a heater, or where the humidity is high.