Using The Hidden Commands; Performing Commands Using The Receiver; Performing Commands Using The Supplied Remote Control; Changing The Remote Control Code - Sony STR-ZA5000ES Guide D'installation

Using the hidden commands

Performing commands using the receiver

This receiver allows you to perform various commands using buttons on the front panel.
PING ENTER

Function
User initialize (Memory Clear)
Sound Field Clear
Settings Lock
Command mode
(Remote Controller)

Performing commands using the supplied remote control

This receiver allows you to perform various commands using the supplied remote control.

Changing the remote control code

1
While holding down MAIN, press MAIN .
MAIN will start flashing.
2
Press CUSTOM PRESET 1 or 2 to select AV1 or AV2 as needed.
MAIN will stop flashing and light up in red.
3
Press .
MAIN will start flashing again.
4
Press again to set the command mode.
AMP
MENU MULTI ST.
2CH/DIRECT
Operation
Hold  for 5 seconds in standby mode.
Hold down MULTI.ST. and press  in standby mode.
Hold down PING and AMP MENU and press ENTER while the
receiver is turned on.
Hold down 2CH/DIRECT and press  in standby mode.
23
GB