The Remote Control; Changing The Batteries - GUTMANN CAMPO II 05 Mode D'emploi

Instruction Manual
The functions of the hood as well as the
power level of the external motor can be
controlled in two different ways:
1. Operation via remote control
(recommended)
2. Operation via switch
gency function)

1. The remote control

ON/OFF
To switch on, press the field with the
ON/OFF symbol. The fan runs at the 3.
level. To switch off, press the ON/OFF
symbol again. Increasing fan power
Press the symbol Increase fan power.
The fan power is increased by one level
each time the field is pressed.
Reducing fan power
Press the symbol Reduce fan power.
The fan power is reduced by one level
each time the field is pressed until level
1 is reached.
Lighting
Press the button with the lighting symbol
to switch on the lighting. The lighting is
switched off by pressing the button
again. The lighting is dimmed by press-
ing and holding the lighting symbol.
Intensive level
Maximum fan power is reached by
pressing the button Intensive level. The
fan power switches back by one level
after 5 minutes.
Automatic follow-up time
The automatic follow-up time is acti-
vated by pressing the field with the Fol-
low-up time symbol. The follow-up time
(is an emer-
symbol (LED) lights up. The extractor
hood switches from level 3 back top
level 1 and runs at this level ~15 min-
utes before switching off.
Filter saturation: (1) Button pressures
(~15sec.) to a red LED

Changing the batteries:

The battery cover is situated on the back
of the remote control. Lift the cover with
thumb and first finger until the magnetic
contact that holds the battery cover re-
leases. Now remove the empty batteries
and replace them with new batteries of
the same type.
Caution: Do not dispose of empty batter-
ies with your normal household waste!
Technical data
Dimensions: 230 x 34 x 10mm
Battery: 2 lithium batteries
Type: CR 2032 3 V
Infrared range: ~ 2m
en
goes off !
17