The Remote Control; Changing The Batteries - GUTMANN SOMBRA II Mode D'emploi

EN
1
2
3

1. The remote control

(six control fields)
ON/OFF (1)
To switch on, press the field with the
ON/OFF symbol. The fan runs at the 1.
level. To switch off, press the ON/OFF
symbol again. Grease filter saturation
limit: Button pressures (~15sec.) to a
red LED goes off !
Increasing fan power (2)
Press the symbol Increase fan power.
The fan power is increased by one level
each time the field is pressed.
Reducing fan power (3)
-
Press the symbol Reduce fan power.
The fan power is reduced by one level
each time the field is pressed until
level 1 is reached.
Lighting (4)
Press the button with the lighting symbol
to switch on the lighting. The lighting is
switched off by pressing the button
again. The lighting is dimmed by press-
ing and holding the lighting symbol.
Colour temperature setting TW (6)
The colour temperature of the LED light-
ing can be infinitely adjusted between
2700K and 6500K.
Press and hold the delay button (6) to
adjust, the LEDs start to change the
colour temperature. When the desired
14
setting is reached, release the button,
4
the colour setting is saved.
( The fan therefor has to be stopped - TW -
function is deactivated when the red LED
flashes! )
Intensive level (5)
Maximum fan power is reached by
5
pressing the button Intensive level. The
fan power switches back by one level
after 5 minutes.
6
Automatic follow-up time (6)
The automatic follow-up time is activat-
ed by pressing the field with the Follow-
up time symbol. The follow-up time sym-
bol (LED) lights up. The extractor hood
switches from level 3 back top level 1
and runs at this level ~15 minutes be-
fore switching off.
Grease filter cleaning display
If the grease filter indicator lights up (red
LED), the filter must be cleaned. After
cleaning the filter, hold down the ON/
OFF switch (1) on the remote control or
the toggle switch (fan symbol) on the
hood for at least 10 seconds. The indi-
cator light goes out.
( The device must be in ON mode - TW -
function is deactivated when the red LED
flashes! )

Changing the batteries:

The battery cover is located on the back
of the remote control. Unscrew the Phil-
lips screw and lift it with thumb and in-
dex finger until the magnetic contact
which holds the battery cover is re-
leased. Now remove the empty batteries
and replace them with the same type.
Replace the battery cover and screw it
tight. Attention: Dispose of empty batter-
ies properly !
Technical data
Dimensions:
230 x 34 x 10mm
Battery: 2Pcs.lithium
Type: CR 2032 3 V
Infrared range: ~ 2m