Replacing The Light Bulbs - GUTMANN CAMPO II 05 Mode D'emploi

g u a r a n t e e wh a t s o e ve r
discolouration caused by the use of
a g g r e s s i v e c l e a n i n g
Temperatures exceeding 55 degrees
must also be avoided.

Replacing the light bulbs

Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
Replace faulty lights through new ones
immediately.
Please cut the connection between the
extractor hood and the power supply
system!
The lightings remain hot for some time.
Please wait therefore for some time till
the lightings have cooled off.
After cooling-off the glass cover is to be
removed with a small screwdriver. Then
the lighting can be taken out. Please
avoid any skin contact with the luminous
means. After the exchange press the
glass pane lightly to a certain extent
(lock in of the pane).
Restore the power by inserting the
mains plug or switching on the fuse.
Note: If the light does not function,
check that the bulbs have been inserted
correctly.
f o r a n y
Carbon, C-Version
a g e n t s .
Expansion: page: 65
Maintenance: separate instructions
Carbon.
Dysfunctions
Please refer to our customer service if
- the extractor hood produces too
much undefined noise and the con-
trol of the exhaust air path reveils
no faults;
- the supercharger works faulty;
- the circuit operates invalid.
Please indicate your type of extractor
hood and the series number. These
information's are mentioned on the type
sheet which is situated inside the hood
on the filter.
en
21