Get Started; Install Filters - Philips AC4012 Mode D'emploi

3 Get started

Install filters
The air purifier comes with all filters fitted
inside, but you have to remove the packaging
of the filters before you can use it. Remove all
filters, unpack them, and place them back into
the air purifier as described below.
Tip
•
When you remove or insert filters, place the
purifier against a wall for more stability.
Note
•
Insert the filters in the correct position.
•
Make sure you place the filters in the order of
HEPA filter, activated carbon filter, and finally
the pre-filter.
•
Make sure that the side with the tag is pointing
towards you.
1
Place your fingers in the recesses of the
side panels and gently pull the top part of
the front panel towards you.
2
Gently pull the bottom of the panel out
(1), then lift the top part of the front
panel towards you (2).
2
1
3
Remove all the filters from the purifier.
4
Remove all packaging material from the
filters.
5
Put the filters back into the purifier.
EN
7