Getting Started; Install Filters - Philips AC4084 Mode D'emploi

3 Getting started

Install filters

The appliance comes with all filters fitted inside.
Remove the packaging of the filters before you
can use the appliance. Remove all filters, unpack
them, and place them back into the appliance
described as follows:
Tip
•
When you remove or insert filters, place the
appliance against a wall for more stability.
Note
•
Insert the filters in the correct position.
•
Make sure that you place the filters in the order
of HEPA filter, activated carbon filter, Multi-care
filter, and finally the pre-filter.
•
The Multi-care filter is sold separately from
AC4084.
•
Make sure that the side with the tag is pointing
towards you.
1
Place your fingers in the recesses of the
side panels.
2
Gently pull the top part of the front panel
out, then lift the top part of the front panel
towards you.
2
1
8 EN
3
Remove all the filters from the appliance.
4
Remove all packaging material from the
filters.
5
Put the filters back into the appliance.
6
Slide the Multi-care filter (if available) into
the pre-filter.