Replacing The Filters; Replace The Multi-Care Filter - Philips AC4084 Mode D'emploi

7 Replacing the
filters
The filter lights ( /
filter has to be replaced.
Note
•
If you remove the front panel for filter changing
while the appliance is switched on, all lights on
the control panel are off and the appliance stops
operating.
•
Once the front panel is placed back to the
appliance, all lights flash twice. Then, the
appliance returns to its operating state.

Replace the Multi-care filter

Note
•
The Multi-care filter is available for AC4085
only. For AC4084, the Multi-care filter is sold
separately.
•
The Multi-care filter is not washable nor vacuum
cleanable.
Replace the Multi-care filter when the filter light
flashes.
/ ) indicate which
Tip
•
When you remove or insert filters, place the
appliance against a wall for more stability.
Note
•
Insert the filters in the correct position.
•
Make sure that you place the filters in the order
of HEPA filter, activated carbon filter, Multi-care
filter, and finally the pre-filter.
•
Make sure that the side with the tag is pointing
towards you.
1
Switch off the appliance and unplug it.
2
Place your fingers in the recesses of the
side panels.
3
Gently pull the bottom of the panel out,
then lift the top part of the front panel
towards you.
2
1
EN 25