Cleaning The Air Quality Sensor; Replacing The Lter; Filter Replacement Indicator - Philips DE5205 Mode D'emploi

Cleaning the air quality
sensor
Clean the air quality sensor every
2 months for optimal functioning of the
dehumidi er.
Note
If the humidity level in the room
•
is very high, condensation may
develop on the air quality sensor
and the air quality light may indicate
a more poor air quality even though
the air quality is actually good. If this
occurs, clean the air quality sensor
or use the dehumidi er on a manual
speed setting.
If the dehumidi er is used in a dusty
•
environment, it may need to be
cleaned more often.
1
Switch o the dehumidi er and
unplug from the wall outlet.
2
Clean the air quality sensor inlet and
outlet with a soft brush ( g.ƒ).
3
Remove the air quality sensor cover
( g.„).
4
Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab ( g....).
5
Dry all parts thoroughly with a dry
cotton swab.
6
Reattach the air quality sensor cover
( g.†).
14 EN
7 Replacing the
filter
Filter replacement
indicator
This dehumidi er is equipped with a
lter replacement indicator to make sure
that the air lter is in optimal condition
when the dehumidi er is operating.
When the lter needs to be replaced,
the lter replacement alert
on the screen.
If the lter is not replaced in 14 days,
the dehumidi er will stop operating and
automatically lock. You need to replace
the lter immediately.

Replacing the lter

Note
The lter is not washable nor
•
reusable.
Always turn o the dehumidi er and
•
unplug from the electrical outlet
before replacing the lter.
Do not clean the lter with a
•
vacuum.
Replace the lter when A5 and
display on the screen.
1
Switch o the dehumidi er and
unplug from the wall outlet.
2
Take out the used lter according to
the lter alert light status displayed
on the screen. Discard used lters
( g.‡).
displays