Adding The Multi-Care Filter; Activate The Multi-Care Filter - Philips AC4084 Mode D'emploi

8 Adding the
Multi-care filter
Note
•
This is applicable only for AC4084.
AC4084 comes with the pre-filter, activated
carbon filter and the HEPA filter. For this
appliance, only the filter light
light (activated carbon filter and HEPA
filter) are activated.
To enjoy the benefits of the Multi-care filter,
you can purchase this filter separately. In
combination with the HEPA filter, the multi-care
filter filters out dust, pollen and ultra-fine
particles.

Activate the Multi-care filter

After you have installed the Multi-care filter, you
can activate it as follows:
Note
•
For information of how to install the Multi-care
filter, see the chapter 'Replace the filters', section
'Replace the Multi-care filter'.
1
Switch off the appliance.
2
Press the RESET button once.
EN
30
/ and the filter
» The filter lights
on. The filter light
3
Press and hold the RESET button for two
seconds.
» The Multi-care filter lifetime is
activated. The filter light
Note
•
To deactivate the multi-care lifetime, press and
hold the RESET button again for two seconds.
Then the filter light is off.
/ , and are
is off.
is on.