Your Air Purifier; Product Overview; Controls Overview; Getting Started - Philips 1000i Série Mode D'emploi

2 Your air purifier

Congratulations on your purchase, and
welcome to Philips!
To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.

Product overview

A Control panel
B Air quality light
C
Air outlet
D Air quality sensor
NanoProtect filter Series 3
E
(FY1410)
F
NanoProtect filter AC (FY1413)
G
Pre-filter
H Air inlet
I Front panel

Controls overview

J On/Off button
K Night sensing mode button
L Display screen
M Fan speed button
N Child lock button

3 Getting started

Installing the filter

Note
• Make sure the air purifier is unplugged
from the electrical outlet before
installing the filter.
• Make sure the side of the filter with the
tag is pointing towards you.
1
Pull the bottom part of the front
panel and then gently lift to remove
it from the air purifier (Fig.c).
2
Press the clip down (1) and pull the
pre-filter towards you (2) (Fig.d).
3
Remove all filters (Fig.e).
4
Remove all packaging materials
from the filter (Fig.f).
5
Place the thick filter (FY1410) into
the air purifier and then the thin AC
filter (FY1413) (Fig.g). The model
numbers are shown on each filter.
6
Attach the pre-filter back into the
air purifier (Fig.h).
Note
• Make sure the side with the clip is
pointing towards you, and that all
hooks of the pre-filter are properly
attached to the purifier.
7
Reattach the front panel by
pressing the top part of the panel
onto the top of the air purifier (1).
Then, gently push the panel against
the body of the air purifier (2)
(Fig.i).
8
Wash your hands thoroughly after
installing filters.
EN
5