Get Started; Install Ilters - Philips AC4012 Mode D'emploi

3 Get started

Install ilters
The air puriier comes with all ilters itted
inside, but you have to remove the packaging
of the ilters before you can use it. Remove all
ilters, unpack them, and place them back into
the air puriier as described below.
Tip
•
When you remove or insert ilters, place the
puriier against a wall for more stability.
Note
•
Insert the ilters in the correct position.
•
Make sure you place the ilters in the order of
HEPA ilter, activated carbon ilter, and inally
the pre-ilter.
•
Make sure that the side with the tag is pointing
towards you.
1
Place your ingers in the recesses of the
side panels and gently pull the top part of
the front panel towards you.
2
Gently pull the bottom of the panel out
(1), then lift the top part of the front
panel towards you (2).
2
1
3
Remove all the ilters from the puriier.
4
Remove all packaging material from the
ilters.
5
Put the ilters back into the puriier.
EN 7