Product Components; Installation - Hach 8000A Manuel D'utilisation

• HIAC/ROYCO Sensor JS, JA, CM, HR & E Series are all compatible.
These sensors must be interfaced with a Remote Power Supply
(Model RPS-2).
• Model 346 is compatible. Cable 033C540-01 is required for
connection.
Samplers
• HIAC/ROYCO Models 3000, 3000A, 3200, Dry Sample Feeder (DSF),
CLS, ASAP, ABS, ABS 2 and the Syringe Driven Sampler (SDS).
Transducers
• Analog transducers that furnish 4-20 mA current source signals are
compatible. However, automatic conversion of the 4-20 mA signal to
appropriate units is provided only for transducers sold by
HIAC/ROYCO specifically for use with the Model 8000A. All
transducers must use standard pinning in 9-pin amp connectors.

Product components

Make sure that all components have been received. Refer to
any items are missing or damaged, contact the manufacturer or a sales
representative immediately.
Figure 3 Instrument components
Figure 3. If
1 7 pin, auxiliary port connector
2 Fuse (2x) (T, 1A, 250V)
3 4-pin Alarm port connector

Installation

Electrocution hazard. Always remove power to the instrument before
making electrical connections.
4 Thermal printer paper
5 Power cord (US)
6 Power cord (European)
D A N G E R
English 7