System Configuration Example; Rear Panel Connections - Hach 8000A Manuel D'utilisation

System configuration example

Figure 1 Typical Model 8000A system
1 Sampler
2 Sensor
3 Sample container

Rear panel connections

D A N G E R
Electrocution hazards. Connect the instrument only to ancillary
equipment that has an appropriate safety assessment.
Figure 2 shows the connections on the rear panels of the counters.
Install all system components before connections are made.
6 English
4 Signal
5 Particle counter
Figure 2 Rear panel connections
1 Power connector (Common housing
includes connector, power fuse)
2 On/Off switch
3 Transducer connection (3x)
4 Alarm input (Not for use with
8011 or 8012 systems. No user
connection detail provided.)
5 Auxiliary input (Not for use with
8011 or 8012 systems. No user
connection detail provided.)
6 Sensor connection (DP-15P)
Sensor, sampler, and transducer compatibility
The instrument is compatible with most currently manufactured
HIAC/ROYCO equipment.
Sensors
• All air or liquid laser diode sensors are directly compatible.
7 Hi Out (Not for use with 8011 or
8012 systems. No user connection
detail provided.)
8 Low Out (Not for use with 8011 or
8012 systems. No user connection
detail provided.)
9 Host connection (Not for use with
8011 or 8012 systems. No user
connection detail provided.)
10 Slave connection (Not for use with
8011 or 8012 systems. No user
connection detail provided. )
11 Sampler connection (Not for use
with 8011 or 8012 systems. No
user connection detail provided. )