Storage - RIDGID HD14000 Mode D'emploi

STORAGE

When vacuuming is complete, your RIDGID Wet/Dry Vac
has convenient storage locations.
ACCESSORY STORAGE (Fig. 11)
1. For Storage: Slide the Extension Wands (L) and the
Accessories onto the Caster Feet Posts.
2. To Remove Wands and Accessories: Lightly rotate
and pull upward.
3. For extra storage of Accessories use the Accessory
Caddy (J). The Car Nozzle (O) fits in the center opening
while other Accessories can be snapped into the Two
Side Clips.
CORD STORAGE (Fig. 11)
1. To Store Cord: Wrap the Power Cord around the top
Carry Handle / Power Cord Wrap Assembly (D) beneath
the Two Tabs.
2. Secure the Power Cord using the Cord Clip on the
Polarized Plug.
HOSE STORAGE (Fig. 11)
1. The Tug-A-Long Positive Locking Hose with Dual-Flex
(K) may be stored around the Powerhead Assembly (A)
using the Two Hose Storage Clips (F).
LOCKING ACCESSORIES (Fig. 11)
Your RIDGID Wet/Dry Vac includes Locking Accessories to
prevent the Accessories from falling off when in use.
1. To Connect the Locking Accessories: Align the Nozzle
Ridges of the Accessory with the Locking Tab of your
Extension Wand (L). Press to secure the Nozzle to the
Extension Wand.
2 To Disconnect the Locking Accessories: Twist the
Nozzle and Extension Wand (L) to disengage the Nozzle
Ridges and pull. You may also press the Locking Tab
and pull to disengage.
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings
blocked; keep free of dust, lint, hair or anything
that may reduce air flow.
CAUTION:
Do not operate vacuum while the hose is still
wrapped around the powerhead assembly in the
storage position.
SP7050-2 ESF.indb 8 SP7050-2 ESF.indb 8
(N)
(O)
(K)
(F)
(O)
(L)
(L)
Locking
Tab
Nozzle
Ridges
(N)
8
Fig. 11
(J)
(M)
Power Cord
Polarized
(D)
Plug Clip
Caster Foot Post
3/2/21 12:12 PM 3/2/21 12:12 PM