Inserting The 3D Stirrer; Inserting The Twin Whisk; Removing Tools; Inserting The Shredder Attach- Ment With Shredding Discs - Bosch MCC9555FWC Manuel D'utilisation

Inserting the 3D stirrer

Place the stirrer on the tool holder.
1.
a The tool will noticeably engage.
Close and lock the lid.
2.

Inserting the twin whisk

Place the twin whisk on the tool
1.
holder.
a The tool will noticeably engage.
Close and lock the lid.
2.

Removing tools

WARNING
Risk of burns!
When removing tools, hot liquid may
slop out.
Remove tools carefully, always us-
▶
ing the spatula.
Wear oven gloves.
▶
Tools and accessories en
Open the lid completely.
1.
→ "Opening and closing the lid",
Page 94
Use the opening in the handle of
2.
the spatula to pick up the tool
handle.
Carefully lift the tool out with the
3.
spatula.
Tips
¡ Put out a heat-resistant object
ready so you can set the utilised
tool down on it, e.g. a plate.
¡ Clean all parts immediately after
use so residues do not dry on.
Inserting the shredder attach-
ment with shredding discs
The shredder attachment consists of
3 parts: the drive shaft, the inner lid
with feeding tube and the pusher.
You can cut and grate ingredients
when used in combination with the
shredding discs.
WARNING
Risk of cutting!
The cutting discs have sharp edges.
Only grip the cutting discs by the
▶
plastic ring in the centre.
Do not reach into the filling shaft.
▶
Only use the pusher to push down
▶
ingredients.
Release the inner lid and remove.
1.
Open the outer lid with seal.
2.
91