Danger Of Fire - DS Produkte XL-602-40 Mode D'emploi

■ Connect the device only to a properly installed plug socket with safety contacts
whose mains voltage corresponds to the data on the rating plate. The socket must
also remain readily accessible after connection. Only use suitable extension cables
whose technical data is the same as that of the device.
■ Should the device fall into water, switch off the power supply immediately. Do not att-
empt to pull the device out of the water while it is still connected to the mains power!
■ Never touch the mains plug, the mains cable or the device with wet or damp hands.
■ Never suck up liquids. Do not pour liquids into the dust container. Keep the motor
unit away from moisture or wet conditions!
■ Make sure that the mains cable is not squashed, bent or laid over sharp edges and
does not come into contact with hot surfaces. Do not wrap the mains cable around
the device (danger of the cable breaking).
■ Switch off the device and pull the mains plug out of the plug socket:
– in the event of a thunderstorm,
– in the event of damage / faults (e. g. unusual noises, odour or smoke development)
– if liquids have been sucked up,
– if the device has been dropped.

Danger of Fire

■ Do not use the device in rooms containing easily ignitable substances or poisonous
and explosive fumes.
■ Do not use the device in the vicinity of highly fl ammable materials (curtains, textiles,
etc.).
■ Do not cover the device during operation in order to prevent it from catching fi re. Do
not insert anything into the ventilation openings of the device and make sure that
these do not become clogged.
■ In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi re
blanket or a suitable fi re extinguisher.
Danger of Damage to Material, Property and the Device
■ The device should only be used if it has been completely and correctly assembled!
The dust container and the fi lters must be inserted and must not be damaged.
If the dirt were to get inside the motor unit, this could damage the motor.
■ The device must be switched off when inserting or removing the mains plug. Always
pull the mains plug and never the mains cable to disconnect the device from the
mains power.
■ Note the MAX marking on the dust container. If during use the marking is reached,
empty the dust container. The fi lters must also be regularly cleaned in order to pre-
vent overloading of the motor.
■ The dust container and the fi lters must be completely dried after washing before they
can be inserted back into the device.
■ Protect the device from heat, naked fl ames, extreme temperatures, persistent mois-
ture, wet conditions and collisions.
■ Use only original spare parts from the manufacturer.
■ Keep the device out of the reach of children and animals in a cool, dry place which
is protected from direct sunlight.
15 EN