Beem Joy V2 Mode D'emploi page 35

EN
Inserting the permanent filter
Pull the filter holder (20) out of the ap-
‹
pliance.
Insert the permanent filter (18) into the
‹
filter holder (20) from above.
NOTE
► When inserting the permanent filter
(18) make sure that it snaps into the
flat part in the filter holder (20). Pay
attention to the marks (image
Brewing coffee
Fill the water tank with water as de-
‹
scribed in the section Filling with
water (page 32).
Insert the permanent filter (18) into
‹
the filter holder (20) as described in
the section Inserting the permanent
filter (page 33).
Put the desired quantity of coffee
‹
powder into the filter.
Recommendation: one teaspoon (ap-
prox. 4-6 g) per cup.
Push the filter holder back into the ap-
‹
pliance until it stops.
Place the glass jug (21) with lid (22)
‹
onto the hotplate (17).
NOTE
► Make sure that the glass jug (21)
is standing in the middle under the
filter holder (20).
BEEM - Elements of Lifestyle
Press the
‹
ing coffee. The red indicator light
"Coffee machine" (25) lights up. The
brewing process begins.
Roughly 1 minute after brewing has
‹
completed, you can remove the glass
jug (21) and pour coffee.
After completing the brewing process, the
coffee is kept warm on the hot plate for
about two hours.
A1).
Cancelling the brewing process
Press the
‹
brewing process. The red indicator
light "Coffee machine" (25) extin-
guishes.
Press the button again to restart brew-
‹
ing.
Switching off the coffee machine
Press the
‹
the coffee machine. The red indica-
tor light "Coffee machine" (25) extin-
guishes.
NOTE
► The appliance switches itself off
automatically after 2 hours.
Café Joy V2
button (32) to start brew-
button (32) to cancel the
button (32) to switch off
33