Rinse After Decalcification; Resetting The Descaling Indicator - Graef Salita ES40 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
• Remove the water tank, and fill in fresh water.
• Add the descaling agent. Observe the manufacturer's instructions.
Recommendation of durgol: 125 ml durgol descaler and 500 ml water.
• Switch the unit on. Wait until this heats up.
• Put a vessel underneath the steam distributor.
• Activate the hot water function (see "Activating the hot water function").
• Allow water to run for about 10 seconds.
• Turn the turning head back to the middle and let the mixture work for a few
seconds.
• Activate the hot water function again.
• Allow water to run for about 10 seconds.
• Turn the rotary knob back to centre position.
• Continue descaling the brewing unit.
• Put a large pot underneath the brewing unit.
• Turn the knob to the left and let the water run through for approx. 20 seconds.
• Turn the rotary knob back to centre position. Allow the decalcifying mixture to
take effect.
• Repeat this procedure until the water in the tank is used up.

RINSE AFTER DECALCIFICATION

• Fill the water tank with 1.25 litres of water.
• Put a vessel underneath the steam distributor.
• Activate the hot water function (see "Activating the hot water function").
• Allow water to run for about 10 seconds.
• Turn the turning head back to the middle and let the mixture work for a few
seconds.
• Activate the hot water function again.
• Allow water to run for about 10 seconds.
• Turn the rotary knob back to centre position.
• Continue rinsing the brewing unit.
• Put a large pot underneath the brewing unit.
• Turn the knob to the left and let the water run through for approx. 20 seconds.
• Turn the rotary knob back to centre position.
• Repeat this procedure until the water in the tank is used up.

RESETTING THE DESCALING INDICATOR

After a certain number of cycles, the indicator / decalcifying light flashes very quick-
ly when the machine is switched on. This will remind you to decalcify the machine.
To reset the reminder, turn the knob to the left, right, and center within 3 seconds.
DE
EN
FR
NL
ES
IT
DK
27

Publicité

Table des Matières
loading

Table des Matières