Behaviour In An Emergency Situation; Safe Handling Of Fuels; Description Of Device / Spare Parts - ATIKA BF 43-2 Notice Originale

− Damaged guards and parts must be properly repaired or
exchanged by a recognized, specialist workshop; insofar
as nothing else is stated in the instructions for use.
− Damaged or illegible security labels have to be replaced.
• Do not allow any tool key to be plugged in!
Before switching on, check always that all tools are
removed.
• Store unused equipment in a dry, locked place out of the
reach of children.
Do not carry out repair operations on the machine other
than those described in section "Maintenance and care"
but contact the manufacturer or authorized customer
service centre.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.

Behaviour in an emergency situation

Initiate all required first aid measures suited for the injury
and seek qualified medical advice as quickly as possible.
Protect the injured person against further injuries and
immobilise the injured person.
Safety instructions - Safe handling of fuels
Fuels and fuel vapours are inflammable and may
cause serious injury on the skin or when inhaled.
Therefore be careful and provide sufficient
ventilation when handling with fuels.
• Do not smoke and avoid open flames when fuelling.
• Wear gloves when fuelling.
• Do not fuel in closed rooms.
• Stop the device and allow it to cool down.
• Carefully close the tank cap after fuelling and check that it
does not get loose during operation.
• Avoid spilling of fuel or oil. Clean the device immediately
when you have spilled fuel or oil. Change your clothes
immediately when you have spilled fuel or oil on them.
•
Make sure that no fuel can enter the soil.
• Check that there is no leakage on the tank cap and fuel
lines. If there are leaks this product may not be started.
• Never use a device with damaged ignition cable and spark
plug connector. Risk of sparking.
• Only transport and store fuels in containers approved and
identified for this.
• Keep children away from fuels.
• Do not handle and store fuels close to combustible and
highly inflammable materials as well as sparks and open
flames.
• Go away at least three meters from the fuelling place to
start the device.
22
Description of device
Please refer to the attached assembly and operating
instruction sheet.
Pos. Denomination
1 Drive unit
2
Lower tube shaft with angular gear
3 Handle with safety switch
4 Carrying strap
5 Handle
6 Safety guard
7
Cutting blade
8 Thread spool
8A Thread spool roll
8B Spool cover
8C Washer
8B Compression spring
9 Fuel mixing can
10 Locking handle
11 Allen key, size 4
12 Allen key, size 5
13
Open-end wrench, size 8/10
14 Socket wrench
15 Screwdriver
16 Cable tie
17 Gas cable
18
Air filter cover
19 Spark plug connector
20 Silencer
21 Cranking handle
22 Fuel tank
23
Tank cap
24 Choke lever
25 Priming pump
26 Suspension eye
27 Angular gear
28
Safety guard holder
29 Thread knife
30 Safety handle
31 Throttle lever lock
32 Cold start switch
33
ON/OFF switch
34 Throttle lever
35 Operating instruction manual
36 Assembly and operating instruction sheet
37 Safety label
38
Air filter cover
39 Air filter
40 Fuel filter
41 Spark plug
42 Hexagon nut
43
Cover
44 Spacer washer
45 Thumb screw
46 Accessories bag - fitting tools
47 Transport guard for cutting blade
48
Transport guard for thread knife
Order-No
385810
385805
382826
385806
385804
385803
385838
385839
385840
385837
380786
385820
385814
385817
385825
385807
385808
385800
385801
385830
385821
385822
385819
385841
385834
385833
385832
385835
385836