Lubrication; Checking The Seal - Dovre 2020 Installation Et Mode D'emploi

4. Rub the glass clean with a dry cloth or kitchen tis-
sue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.

Lubrication

Although cast-iron is slightly self-lubricating, you will
still need to lubricate moving parts frequently.
Lubricate the moving parts (such as guide sys-
tems,hinge pins, latches and air slides) with heat
resistant grease that is available in the specialist
trade.
Touching-up the paint finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.

Checking the seal

Check whether the door sealing rope is still in good
condition and works well. The sealing rope is sub-
ject to wear and will need to be replaced over time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Allow the sealant to harden fully before lighting
the stove, as any moisture in the sealant will
form bubbles, resulting in a new air leak.
Adjust door
Check if the door closes properly; if necessary, adjust
the hinge post; see next figure.
22
1. Open the door of the appliance; the hinge post is
now visible and accessible.
2. Loosen the two mounting bolts of the hinge post
slightly. The mounting bolts are located on the
inside of the stove.
3. Move the hinge post into the desired position.
4. Use the adjusting screws to adjust the hinge post
widthwise in the appliance.
5. Tighten the two mounting bolts and check whether
the door closes properly.
Subject to change because of technical improvements