Installation; Preparation; Fitting The Handle - Dovre 2020 Installation Et Mode D'emploi

The opening direction of the door can be changed.
The appliance is supplied with a door turning to the
right. An optional locking rod is required for a left-
turning door (supplied separately). The instructions
for changing the door swing direction are provided
with this locking rod.
The appliance is supplied with a connecting kit for
the outside air supply.
The appliance is not suitable for continuous use.
The insert fireplace has an integrated convection
system. This means that when installing the appli-
ance it is not necessary for a separate convection
space to be built and the use of air inlet and outlet
grates for convection is not necessary.
The space between the cast-iron fireplace and
steel convection box serves as the convection
space. Surrounding air is drawn in at the bot-
tom of the appliance. The air is directed to the
fireplace where it is heated. The heated air then
leaves the front side of the convection space
through the air opening on the upper side of the
fireplace.
The appliance is equipped with two additional con-
nections in order to transport convection heat to
other areas.
The appliance is equipped with two built-in fans
that aid convection. The turning speed of the fans
can be adjusted using a speed control. This speed
control is supplied with the appliance. The fan and
speed control are connected to the mains electric
circuit; see paragraph "Connecting fan to the
mains".
The fan works thermostatically. That means
that the fan only starts to operate if the
insert fireplace is sufficiently warm and the
fan switches off once the insert fireplace
has cooled sufficiently.
The appliance can be supplied with an outer frame
to which you can attach a decorative frame. The
decorative frame is supplied as an option.
Subject to change because of technical improvements

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
1. Open the stove door.
2. Remove the fire-resistant inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the sur-
roundings.

Fitting the handle

The appliance is supplied with a loose handle, the so-
called "cold hand".
The form of the "cold hand" depends on the model of
the appliance.
Fit the wooden handle to the adaptor using screw
M8x50 provided; see following figure.
09-20015.088
See the next figure for opening the door.
11