Water Meter Installation; Pressure Sensor Installation; Level Sensor Installation; Sacrificial Anode - Lorentz PS Série Manuel D'installation Et De Fonctionnement

58 Pump Accessories Installation
Only for Controllers with DataModule
For setup of DataModule related accessories, the LORENTZ
PumpScanner application for Android™ must be used, cf.
"10.4 Parameter Setting (with DataModule only)" on page
64.

9.4 Water Meter Installation

For information on the water meter installation, please refer
to the manufactures manual. Pay attention to the installa-
tion position, flow direction and the calming section.
Basic rule: The water meter should have 10 nominal
diameters straight pipe ahead of the meter and 5 nominal
straight pipe diameters after to ensure proper flow through
the meter

9.5 Pressure Sensor Installation

The LORENTZ range of liquid pressure sensors are used to
measure the pressure in a pipe. The sensors are commonly
used to measure the pressure at a well head or feeding into
irrigation systems. The liquid Pressure Sensor must be used
with a PS DataModule equipped controller
For more information about the pressure sensor please refer
to the COMPASS datasheet. Ensure that the pressure sensor
is suitable for your application regarding pressure range and
temperature resistance.

9.6 Level Sensor Installation

The LORENTZ range of liquid level sensors use pressure to
measure the level or water in a well or tank. The sensors
can be used for long term water level monitoring and also
for pump control in applications where a well probe cannot
be used. The liquid Level Sensor must be used with a PS
DataModule equipped controller.
For further information about the Level sensor please refer
to the COMPASS datasheet.

9.7 Sacrificial Anode

The LORENTZ Sacrificial Anode is designed for use with
LORENTZ pump ends. Where solar pump ends operate in ag-
gressive water conditions acidic water can attacks the pas-
sive layer of the high quality-steel pump end. This corrosion
reduces the life time of the product. The LORENTZ Sacrificial
Anode contributes to the protection of the pump system
from this type of corrosion and extends the pumps life.
For further information about the Sacrificial Anode please
refer to the COMPASS datasheet.
Figure 25: Sacrificial Anode for HR pumps