Lorentz PS Série Manuel D'installation Et De Fonctionnement page 36

34 Controller Installation
Battery Mode (not PS4000)
The battery mode is activated in the same way as for PS
controllers without pre-wired plugs. The controller case has
to be opened and a jumper must be connected between
terminals 6 and 7, refer to "7.7.1.5 Input Wiring for Bat-
tery-based Systems" on page 30.
Figure 10: MC4 plug for power input Figure 11: Plug W for motor cable
Figure 12: 2-pin plug
3
1 2