Operating The Pump - Lorentz PS Série Manuel D'installation Et De Fonctionnement

60

Operating the Pump

10 Operating the Pump
This graphic displays the LED and label layout for PS150-UL,
PS200-UL and PS600 to PS4000. PS150 and PS200 control-
lers have LED indicators directly on-board.
The LED status indication described in "10.1 LED Status"
applies to all types of controllers unless specified differently.
Does not work as power disconnect switch.
When switched OFF/ON during operation, it resets the system
Battery status indication with "TANK FULL" LED
POWER SWITCH (ON/OFF)
Only switches pump operation ON/OFF.
LED status
PS150 to PS1800 only
ON
POWER
OFF
SYSTEM ON
LIGHT GREEN: CONTROLLER
ON, POWER PRESENT
PUMP ON PUMP ON
LIGHT GREEN: MOTOR ON LIGHT GREEN: MOTOR ON
LIGHT RED: OVERLOAD LIGHT RED: OVERLOAD
SOURCE LOW SOURCE LOW
LIGHT FLASHES AFTER LIGHT FLASHES AFTER
WELL HAS RECOVERED WELL HAS RECOVERED
SWITCH ON/OFF TO RESET SWITCH ON/OFF TO RESET
TANK FULL
BATTERY LOW
LIGHT FLASHES UNTIL
BATTERY HAS RECOVERED
www.lorentz.de
v110901