Controller Types - Lorentz PS Série Manuel D'installation Et De Fonctionnement

18 Controller Installation

7.2 Controller Types

Depending on the pump system, the controller will either be
in transparent plastic or aluminium housing.
Controllers in transparent housing have all indicator lights
directly on board. The power on/off switch is located at the
bottom of the housing, next to the cable glands.
The controllers in aluminium housing have indicator lights
and a power on/off switch on the front.
Both controller types function in the same way and are to be
wired according to the instructions in this manual.
NOTE – The on/off switch only affects the
pump operation, it does not work as a
power disconnect switch.
Figure 2: Controller Types
PS150 to PS200 (not UL)
Prewired plugs: If ordered, the controller will have
prewired plugs. In this case, no wiring is needed inside the
controller. Refer to "7.7.2 Controllers with pre-wired Plugs"
on page 32.
Datamodule: The datamodule is an optional internal
component. It allows easy configuration of the pump
system using the LORENTZ PumpScanner smartphone appli-
cation. If combined with a PS Communicator it also allows
remote pump monitoring and management with LORENTZ
pumpMANAGER. For more information on the DataModule
refer to chapter "11 LORENTZ CONNECTED" on page 65.
For setup of the controller using PumpScanner please refer
to the PumpScanner documentation available on partner-
NET. For more information on pumpMANAGER please go to
www.lorentz.de/connected.
PS150-UL to PS200-UL
PS600 to PS1800
PS4000