Hach ORBISPHERE 51 Série Manuel D'utilisation Simplifié page 10

Masquer les pouces Voir aussi pour ORBISPHERE 51 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
4.4 Instrument connections
Figure 1 Connections - panel (left); wall/pipe (right)
1 Power cable
2 Ethernet cable gland
3 USB-A host connector
4 USB-B 4-pin connector
5 Input/Output 1 cable gland
4.5 Connection to mains power supply
4.5.1 Power supply connection (low voltage instruments)
For low voltage instruments (10-30 VDC), connection to the mains power supply is with a 8-pin
BINDER connector (supplied).
Note: The connectors are grooved to avoid an incorrect fitting to the instrument.
Connect the power cable to the connector as follows:
Figure 2 BINDER connector
10 English
6 K-M1100 LDO Sensor connection (2x)
7 External pressure sensor connection
8 Input/Output 2 cable gland
9 Keylock (wall/pipe mount only)
Pin Connections:
1. Power 10-30 VDC
2. Ground
3. Ground
4. Ground
5. Not used
6. Power 10-30 VDC
7. Power 10-30 VDC
8. Earth
Figure 3 Wiring side view

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Orbisphere 51 analyzer avec k/m1100 sensors série

Table des Matières