Procedure For Parametering Of The Multiline 1000 S; Automatic Mode ( 'Auto' Led Illuminates ) - Ecolab MULTILINE 1000-S Manuel D'utilisation

Operation
7.2

Procedure for parametering of the MULTILINE 1000 S

Fig. 6: Procedure for parametering of the MULTILINE 1000 S
7.2.1
Automatic mode ( 'AUTO' LED illuminates
NOTICE!
Metering can be aborted by pressing the 'ENTER' key.
417101439 Rev. 2-09.2019
Metering starts upon reception of an external start pulse or upon pressing of the
'MAN' button, that is the valve opens and spray air is active.
Time is now counted down; after expiry of the metering time, the valve closes. The
spray air remains active until the end of the after run time (see pre set after run
time).
The 'Finished' signal is transmitted to the exterior after expiry of the after run time.
26
)