Transmitter Operation - Velleman SP200B Mode D'emploi

2. Some G.M. vehicles have a 2 minute's computer timing circuit to check the
vehicle's door to see if it is closed, allowing the vehicle's door handle touch
control to turn on your dome lights when you touch the door handle. This
action will trigger the alarm while the alarm armed. Prevent this situation, on
these cars, cut the orange wire loop and tape both end to delete the voltage
drop sensor.
A. TRANSMITTER OPERATION
Transmitter Button System Function
Button I
Button I - I
Button I
Both Buttons - II
Both Buttons - I
B. CHIRP INDICATORS
Chirp
1 chirp
2 chirps
4 chirps
C. ACTIVE ARMING
1. Press the button I on the transmitter.
2. The siren will chirp once. 3 seconds later, the system will be fully armed.
D. ACTIVE DISARMING
1. Press the button I on the transmitter.
2. The siren will chirp twice to indicate that the alarm is disarmed.
TAMPER DISARMING : If the alarm had been triggered, when you disarm the
alarm, the siren will chirp 4 times.
SP200B
OPERATION MANUAL
Arm / Disarm
Armed and delete
shock sensor
Panic
Programming Shock
Sensitivity
Programming Siren
Tone
Function
Arm
Disarm
Disarm / Intrusion
7
Remark
Press 2 times within 3 seconds
Press and hold for 3 seconds
Upon disarm within 10 seconds,
press both buttons for 2 seconds
then press button II
Upon disarm within 10 seconds,
press both buttons for 2 seconds
then press button I
VELLEMAN