General Specifications - Velleman SP200B Mode D'emploi

REMOTE CONTROL AUTO ALARM SYSTEM
This alarm system will provide years of dependable operation. Yet, quality and
longevity of the system are determined by the installation. For information on
operating the system, read the operation manual.

GENERAL SPECIFICATIONS :

Power Requirements
Fuse Ratings - Red Power wire -
Current Consumption
Arming Delay
Alarm Timer
Triggers inputs
Receiver channel
Learning limitations
A. MOUNTING THE SIREN
1. In the engine compartment, place the siren in a location suitable for best
sound results. Be careful not to mount the unit near exhaust manifolds or
other "hot" equipment and moisture area.
NOTE : Preferred siren position is facing forward (toward front of vehicle).
Siren should not face up.
2. Mark and drill two 3/16" holes to screw on the mounting bracket. With the
screws and lock washers provided, mount the bracket to the vehicle.
3. After mounted the bracket, mount the siren to the bracket with the bolts,
washers and lock washers provided. Adjust the siren angle and tighten bolts.
B. DECALS
Peel the decals from the paper backing and apply them to the inside of your
vehicle's window. These are an effective deterrent to thief. Most thieves pass by
vehicles that equipped with security system.
SP200B
OPERATING MANUAL SP200B
INTRODUCTION
+ 12 Volts & Negative Ground
3 Amps
Less than 10mA Stand By
3 seconds
60 seconds with 2 Cycles Limitation
Minus. 0.6 of volt. drop.
Shock sensor
3 Channels
2 Transmitters
INSTALLATION
3
VELLEMAN