Connecting The Flame Inspection Window (Fig. 10); Assembling The Panels, Models 92-190 - Ferroli TP3 LN 70 Instructions D'utilisation, D'installation Et De Montage

TP3 LN

5.8 Connecting the flame inspection window (Fig. 10)

The flame inspection window features a pressure fitting (1) to be connected via
a silicone hose or copper pipe to the outlet on the burner (2). This operation
allows the air blown by the fan to cool the glass and prevent it from turning
black. Failure to connect the hose or pipe to the window may cause the glass to
break. For Ferroli boilers, configurations other than those indicated above are
also possible, as each combination has been developed in our facilities through
specific laboratory tests.

5.9 Assembling the panels, models 92-190

Assembly sequence (Fig. 11)
a) Position the right and left side panels (pos. 1-2) hooking them to the support (pos. 13). To know which of the two sides is the right or the left,
refer to the hole for the cable gland plate (pos. 6), which must be facing the front of the boiler.
b) Fasten the control panel to the top panel (pos. 3).
c) Rest the top right panel (pos. 3), complete with the control panel, to the side panel (pos. 1) complete with springs, closing pins and nuts (pos.
10-11-12).
d) Insert the bulbs of the instruments into the sheaths as shown in Fig. 20 and make the electrical connection between the control panel and the
power line, burner and any pumps etc. The probes should be inserted fully into the corresponding sockets, to improve contact. Then secure
the capillary tubes with the springs. Close the cover on the electrical panel, pass the burner plug through the side plate (pos. 6) and secure
the cable with the cable gland supplied. Fasten the plate (pos. 6) with the screws (pos. 7).
e) Fit the panel left top (pos. 4) to the left side panel (pos. 2) complete with springs, closing pins and nuts (pos. 10-11-12).
f) Fit the rear panel (pos. 8) to the boiler using the screws (pos. 13).
g) Fasten the rating label to the boiler, see Chap. 1, after having cleaned and degreased the part in question using a suitable solvent, and apply
it so as to ensure perfect adhesion. Do not remove the rating label, as it will lose its adhesiveness.
The rating label is included in the document envelope.
12
11
10
13
2
1
cod. 3545458/0 - 10/2019
1
4
3
12
8
13
7
6
fig. 11
2
fig. 10
11
10
13
EN
39