NovoPress AFP101 Manuel D'utilisation page 18

Press tools
Old press collar (round)
EN
Press collar
M42, M54,
M64, M67,
M66,7 Mapress
M76,1 – M88,9
M108,0
HP35
HP42, HP54
V42, V54
TH40, TH50,
TH63
U40, U50, U63
1. Check whether the nominal width of the press fitting matches the nominal width of the press
collar.
2. Press collar with catch (Fig. 3):
Press the pin (B/Fig. 3) as shown [2.1/Fig. 3], while simultaneously opening the press collar by
pulling apart at the catch (C/Fig. 3).
Press collar without catch (Fig. 5):
Pull the press collar apart.
3. For moving sliding segments: Check the freedom of movement/position of the sliding segments.
4. Place the press collar over the press fitting (Figs. 3+5).
5. Press collar with catch (Fig. 3):
Turn [1/Fig. 3] the catch (C/Fig. 3) towards the pin (B/Fig. 3).
Press the pin (B/Fig. 3) as shown [2.1/Fig. 3], while simultaneously pushing the pin into the catch
(C/Fig. 3) until it engages [2.2/Fig. 3].
The pin (B/Fig. 3) must be pushed in as far as possible. Turn the press collar to the pressing
position.
Adaptor jaw
Device type 2
201 202
 
 
 
 
 
 
 
 


Note
for press collars with movable sliding segments (Fig. 4)!
To ensure that the press collars function correctly, the sliding segments must be free to
move.
The sliding segments are always pressed back automatically into the correct starting
position by springs.
Therefore:
– Ensure that the marking lines on the sliding segments (E/Fig. 4) and the shells
(D/Fig. 4) are in alignment in the starting position.
– If this is not the case, have the press collars repaired at an authorised workshop.
Note!
Always follow the system supplier's instructions when placing the press collar onto the
press fitting.
Adaptor jaw
Device type
2XL
203 221 222 302
   

  
   
 (1.)  (2.)
 
   
   
   
   

  
14
Adaptor jaw
Device type 3
303 321 322 323
   
   
   

(1.) (2.) (1.) (2.)
   
   
   
   

  
324







