Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING: Risk of personal injury. The corner door
should only be opened for cutting inside corners. Keep
hands and body away from cutting area at all times.
Ensure corner door is closed in all other applications.
This feature allows the cutting of an inside corner.
1. Ensure the tool is off and wheel has come to a
complete stop.
2. Turn cornering door locking lever
one full rotation. Grasp the corner door
open as shown in Figure D.
3. Place hands away from the wheel area and position
yourself so the open underside of the shroud is facing
away from you.
4. Turn the tool on and allow the tool to reach full speed
before touching the tool to the work surface.
5. Place the wheel onto the work surface and move the
grinder from right to left to cut around the inside corner
for best dust collection.
6. Remove the tool from work surface before turning tool
off. Allow the tool to stop rotating before laying it down.
7. Close the corner door and lock in place using the
cornering door locking lever
Fig. F
Dust Extraction (Fig. A, G)
WARNING: Use only power tools and dust extractors
recommended by D
WALT with this attachment.
e
For more information about D
compatible with this attachment, please contact your local
dealer, call 1–800–4-D
WALT (1–800–433–9258) or visit our
e
website www.D
WALT.com.
e
WARNING: This attachment must be used with a dust
extractor system. ALWAYS wear certified safety face
or dust mask.
nOTE: Ensure hose connection is secure.
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
All D
WALT dust collection shrouds are designed to work
e
with the D
WALT Air lock™ universal DWV9000 connector.
e
1. Attach the DWV9000 connector
collector hose
17
.
2. Unlock the DWV9000 connector
port
.
8
3. Lock the DWV9000 connector
12
counterclockwise
7
and rotate
12
.
7
12
WALT power tools
e
16
to your dust
16
and slide onto dust
to secure.
16
Fig. G
17
16
8
Traditional dust extractor vacuum
hoses
Attach recommended dust extractor vacuum hose to dust
port
8
.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Hold the side handle and body of the
tool firmly to maintain control of the tool at start up
and during use and until the wheel or accessory stops
rotating. Make sure the wheel has come to a complete
stop be fore laying the tool down.
WARNING: Ensure corner door is closed.
1. Ensure all assembly and adjustment instructions have
been completed.
2. Turn the dust extractor vacuum on as instructed in the
dust extractor vacuum instruction manual.
3. Start grinder as instructed. Refer to Slider Switch.
nOTE: Allow the tool to reach full speed before
applying to the work surface.
Proper Hand Position (Fig. H)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the side
handle
5
, with the other hand on the body of the tool, as
shown in figure H.
English
7
Publicité
Table des Matières
