Activating The Sleep Function; Activating The "I Feel" Function - Dometic FreshJet 1100 Notice D'utilisation

Operating the roof air conditioner
✓ The switch-on and switch-off times are set on the roof air conditioner.
The roof air conditioner starts in the selected air conditioning mode at the
specified time and runs until the second specified time.
➤ Switch the roof air conditioner to stand-by.
Cancelling timer settings
If you have set the timer, you can cancel these settings as follows:
➤ Press the TIMER button five times.
✓ The timer symbol disappears. The setting has been cancelled.
9.10

Activating the sleep function

When the sleep function is activated, the set temperature is modified by 1 °C
after one hour and by 2 °C after two hours to ensure a pleasant temperature
for sleeping.
➤ Set the required temperature (see chapter "Setting the temperature" on
page 66).
➤ Press the SLEEP button.
✓ The
symbol appears in the display.
The sleep function is activated.
9.11

Activating the "I feel" function

When this function is active, the remote control measures the room tempera-
ture and transmits this measurement to the roof air conditioner every
10 minutes. The roof air conditioner adapts the target value to this measure-
ment.
➤ Press the I FEEL button.
➤ Position the remote control so that it points at the IR receiver (fig. 2
page 4) on the control panel. Otherwise, the values cannot be transmitted
to the roof air conditioner.
I
NOTE
The remote control should not be kept in a part of the room that is
considerably warmer or colder than the average room tempera-
ture. It may not, for example, be left in the sun or in front of the roof
air conditioner.
68
Dometic FreshJet
4,
EN