Activating The Sleep Function; Operating The Ambient Lights - Dometic FRESHJET 3000 Notice D'utilisation

FreshJet3000
✓ The switch-off time is set on the roof air conditioner.
Switch the roof air-conditioner to Stand-by.
Cancelling timer settings
If you have set the timer, you can cancel these settings as follows:
➤ Press the
button once.
✓ The timer symbol disappears.
✓ The setting has been cancelled.
7.10

Activating the sleep function

I
NOTE
The sleep function is only available in "Cooling" (
modes.
When the sleep function is activated, the compressor speed and the fan speed is
limited to a lower level to reduce the noise levels for easier sleeping.
➤ Set the required temperature (see chapter "Setting the temperature" on
page 17).
➤ Press the
button.
✓ The
symbol appears in the display.
The sleep function is activated.
➤ To deactivate the sleep function press the
I
NOTE
The sleep function is deactivated if the MODE button is pressed.
7.11

Operating the ambient lights

I
NOTE
The button on the remote control is active even if the remote control
is switched off.
Switching the lights on/off with the control panel
➤ Briefly press the
EN
button to switch the lights on or off.
Operating the roof air conditioner
)" or "Heating" (
button again.
)
19