Activating The Sleep Function; Activating The "I Feel" Function - Dometic FRESHJET FJ 1100 Notice D'utilisation

Dometic FreshJet
9.10

Activating the sleep function

I
NOTE
The sleep function is deactivated in "Circulating air" (
When the sleep function is activated, the set temperature is modified by 1 °C after
one hour and by 2 °C after two hours to ensure a pleasant temperature for sleeping.
➤ Set the required temperature (see chapter "Setting the temperature" on
page 34).
➤ Press the
button.
✓ The
symbol appears in the display.
The sleep function is activated.
➤ To deactivate the sleep function press the
I
NOTE
The sleep function is deactivated if the MODE button is pressed.
9.11

Activating the "I feel" function

When this function is active, the remote control measures the room temperature and
transmits this measurement to the roof air conditioner every 10 minutes. The roof air
conditioner adapts the target value to this measurement. The "I feel" function is only
active when the temperature range is between +18 °C and +29 °C.
➤ Press the
button.
✓ The
symbol appears in the display.
The "I feel" function is activated.
➤ Position the remote control so that it points at the IR receiver (fig. 2
on the control panel. Otherwise, the values cannot be transmitted to the roof air
conditioner.
I
NOTE
The remote control should not be kept in a part of the room that is
considerably warmer or colder than the average room temperature.
It may not, for example, be left in the sun or in front of the roof air
conditioner.
EN
Operating the roof air conditioner
) mode.
button again.
page 4)
4,
37