Hint For Improved Use - Dometic FreshJet 1100 Notice D'utilisation

Dometic FreshJet
Specifying values and transmitting them collectively to the roof air
conditioner
The remote control may not be pointed at the IR receiver (fig. 2
on the control panel during operation.
Specify the required values on the remote control. Once you have made all
your settings, point the remote control to the IR receiver on the control panel
and press the SET – °F/°C button. This transmits the data to the roof air con-
ditioner. The roof air conditioner confirms the receipt of data with a high note.
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig. 2
the control panel, you can activate the remote control or switch it to stand-by
independently from the roof air conditioner:
➤ Press the
button.
9.3

Hint for improved use

The following hints will optimise the performance of your roof air conditioner:
z Improve the heat insulation of your vehicle by sealing gaps and hanging
reflective blinds or curtains on your windows.
z If the vehicle has been subjected to direct sunlight for a long time: Operate
the roof air conditioner in the "Circulating air" (
open for a while before switching on the "Cooling" (
mode.
z Avoid opening doors and windows as far as possible in the "Cooling" (
mode.
z Select an appropriate temperature and blower speed.
z Align the air nozzles sensibly.
z Make sure the air nozzles and intake grille are not covered by cloths,
paper or other objects.
EN
Operating the roof air conditioner
) mode with the windows
) air conditioning
page 4)
4,
page 4) on
4,
)
63