Air Supply; Power Source - Hitachi NT50AF Mode D'emploi Et Consignes De Sécurité

English

AIR SUPPLY

•
Never connect Tool to pressure which potentially exceeds 200
• psi (13.7 bar 14 kgf/cm
Never use non relieving coupler on Tool.

1. Power Source

V Use only clean, dry, regulated compressed air as a power source
for this Tool
V Air compressors used to supply compressed air to this Tool
must comply with the requirements of the latest version of ANSI
Standard B 19.3 "Safety Standard For Compressors For Process
Industries."
V Moisture or oil in the air compressor may accelerate wear and
corrosion in the Tool.
Drain daily.
V Air volume is as important as air pressure. The air volume
supplied to the tool may be inadequate because of undersized
fittings and hoses or from the effects of dirt and water in the
system. Restricted air flow will prevent the tool from receiving
an adequate volume of air, even though the pressure reading is
high. The results will be slow operation, jamming, miss‑feeds
or reduced driving power. Before evaluating tool problems for
these symptoms, trace the air supply from the tool to the supply
source for restrictive connectors, swivel fittings, low points con‑
taining water and anything else that would prevent full volume
flow of air to the tool.
2. Filter‑Regulator‑Lubricator
V A pressure regulator with an operating pressure of 0‑125 psi
(0‑8.6 bar 0‑8.8 kgf/cm
pressure for safe operation of this Tool. Do not connect this Tool
to air pressure which can potentially exceed 200 psi as Tool may
fracture or burst, possibly causing injury.
V Filter‑Regulator‑Lubricator units supply an optimum condition
for the Tool and extend the Tool life.
DANGER
•
NEVER use oxygen or other bottled
gases. Explosion may occur.
WARNING
).
2
) is required to control the operating
2
— 16 —