Start-Up; General Information; User Interface And Navigation; Keyboard And Display - Hach sensION+ DO6 Manuel Utilisateur

4. Start-up

4.1. General information

Important note: before start-up, make sure that the sensor is connected to the measuring instrument.
1. Connect the sensor (if necessary) to the measuring
instrument (Fig. 3, pg. 7).
2. Turn on the instrument.
3. Perform calibration (see pg. 12-14).
4. Take measurement (see pg.10).
Note: With the instrument switched off,
- Press the key and the instrument will begin
measuring.
- Press the key and the instrument will begin
calibration.

4.2 User interface and navigation

4.2.1 Keyboard and display

Figure 4 indicates the instrument keys and display.
1
2
3
8
sensION+ DO 6_HACH_0710.indd ANG:8 sensION+ DO 6_HACH_0710.indd ANG:8
Software version.
Display
1
2
3
4
4
5
Keypad
5
Fig. 4. Keypad description
Instrument Standby screen.
serial number.
Measured DO values (mg/L or %).
Temperature.
Measuring time (hh:mm:ss).
Units of measurement.
Battery indicator.
- Instrument on/off.
- Display light on.
- Start of measuring.
- Start of calibration.
- Selection of temperature units.
- Entry of numerical values during
set-up.
14/9/10 10:51:21 14/9/10 10:51:21