Cancelling The Kitchen Timer; Power Reserve; Insert / Change Batteries; Cleaning And Care - SilverCrest SKR D1 A1 Instructions D'utilisation Et Consignes De Sécurité

At the end of the countdown, an alarm signal
sounds at maximum volume . Press any key to
turn the alarm off . T1 or T2 disappears from
the display 4 .
NOTES:
Timer 1 can be set from 1 minute up to 3 hours
59 minutes in increments of 1 minute . If you set
the countdown between 1 and 4 minutes, the
time will be shown in "mm:ss" format . If you set
the countdown to 5 minutes or more, the time
will be shown in "hh:mm" format .
Timer 2 can be set from 5 minutes up to
3 hours 55 minutes in increments of 5 minutes .
The time will be shown in "hh:mm" format .
If you do not make any changes to the settings
for about 15 seconds, the product will switch
back to the previous operating mode without
saving the settings .
˜ Cancelling the kitchen timer
Briefly press TIMER/SLEEP 8 to select the
timer you wish to cancel (T1 or T2) .
Push and hold VOLUME/START/RESET 6
for 2 seconds until T1 or T2 disappears from
the display 4 .
˜ Power reserve
The power reserve is used to store data /
settings if the product has been accidentally
disconnected from the power supply .
In the event of a power failure, the display will
extinguish, the clock will continue working, but
there will be no alarm .
38 GB/IE
˜ Insert / change batteries
The battery compartment 14 is located on the
bottom of the product .
Open the battery compartment 14 .
Insert 2 batteries (type: 1 .5 V, AA/LR6) into
the battery com partment according to the
polarity marks .
Close the battery compartment 14 .
˜ Cleaning and care
Before cleaning: Unplug the product from the
power supply and remove the batteries .
m
WARNING! Never immerse the product nor
the power adaptor in water or other liquids for
cleaning purposes . Never immerse any of the
product's components under running water .
Clean the product with a slightly moistened
cloth .
Do not allow any water or other liquids enter
the product's interior .
Do not use solvent-based cleaning agents,
abrasives, harsh cleaning solutions or hard
brushes for cleaning .
Let all parts dry afterwards .
˜ Storage
Before storing the product: Remove the
batteries . Store the product in its original
packaging .
Store the product in a dry, secure location
away from children .