Installation Under A Wall Cupboard; Dismantling - SilverCrest SKR D1 A1 Instructions D'utilisation Et Consignes De Sécurité

The surfaces of some items of furniture might
contain components that can soften the rubber
feet of the product . If necessary, place a mat
under the product's rubber feet .
Set up or mount the product in such a way
that the provided ventilation openings and the
loudspeaker 13 are not covered .
Do not operate the product in a hot, wet or
extremely damp environment or in the vicinity
of flammable materials .
The mounting location must be selected so that
the product is not exposed to vapours . Do not
install the product directly over a hotplate .
˜ Installation under a wall
cupboard
Using the supplied mounting plate 9 , you can
install the product e .g . under a wall cupboard .
Proceed as follows to mount the product:
Slide the mounting plate 9 to the rear and
remove it from the product .
Find a suitable installation location for the
product (see "Requirements for the set-up
location") .
Hold the mounting plate 9 under the
installation location . Ensure that the front edge
of the mounting plate is approx . 3 cm behind
the front of the cupboard so that the product
is flush with the cupboard after installation .
The side edges of the mounting plate 9 must
be spaced approx . 6 cm away from adjacent
cabinets or walls .
Mark the 4 mounting points with a pencil .
Using a pin or nail, make a small depression at
the respective marking points . In hardwoods,
drill a shallow hole in the markings using a
Ø 2 .5 mm wood drill bit .
If required, place the supplied spacers 15
between the cupboard and the mounting plate .
If you are using the spacers 15, you will need
3 cm
the long mounting screws 16 .
Screw the mounting plate 9 tight using the
mounting screws (16 or 17) .
With the top of the product against the
mounting plate 9 , push the product back until
6 cm
it clicks into place .
Check to ensure that the product is firmly in
position and safely route the power cable and
the wire aerial .
˜ Dismantling
Pull the product forwards off the mounting
plate 9 .
Unscrew the screws (16 or 17) on the
mounting plate and remove the mounting
plate 9 from the wall cupboard .
GB/IE 31