Installation Under A Wall Cupboard - SilverCrest SKRI 2000 A1 Instructions D'utilisation Et Consignes De Sécurité

Setting up and connecting

Installation under a wall cupboard

With the supplied mounting plate
ample, a wall cupboard. For the installation of the appliance proceed as follows:
♦ Slide the mounting plate
♦ Select a suitable installation location for the appliance (see also the section
Set-up location requirements p. 117).
♦ Hold the mounting plate
edge of the mounting plate
of the cupboard so that, after the installation, the appliance is fl ush with the
cupboard. The side edges of the mounting plate
about 4.5 cm to adjacent cabinets or walls.
NOTICE
► If you wish to install the unit fl ush to the left on an adjacent cabinet or a
wall, remove the safety clip
♦ Mark the 4 securing points with a pencil.
♦ Using a spike or nail, make a small depression at the respective marking points.
♦ If wished, insert the supplied spacer
respective depression on the mounting plate
♦ Firmly screw the mounting plate
SKRI 2000 A1
you can install the appliance under, for ex-
20
to the rear and remove the mounting plate
20
under the installation location. Thereby the front
20
should be approx. 6.8 cm behind the front
20
from the appliance beforehand.
22
with the retaining lug into the
28
.
20
on with the supplied screws (see illustration).
20
20
must have a spacing of
20
GB
.
119