Programming The Kitchen Timer - SilverCrest SKRI 2000 A1 Instructions D'utilisation Et Consignes De Sécurité

Interrupting the kitchen timer.
GB

Programming the kitchen timer

130
♦ When the kitchen timer is running, press the button Timer
Timer on the remote control. The kitchen timer is interrupted. The indicated
37
remaining time begins to blink.
NOTICE
► After approx. 15 seconds the appliance reverts back to the previous opera-
tional mode. Press the button Timer
control, once again to display the remaining time to elapse on the kitchen timer.
♦ To restart the kitchen timer, press the button Timer
on the remote control, once again. The kitchen timer restarts.
♦ To switch the kitchen timer off before the expiry of the set period, press and
hold the the button Timer
until in the display
clock are no longer indicated.
NOTICE
► The kitchen timer is switched off immediately in the event of an alarm
becoming active.
So that it is no longer necessary to continually re-enter them, you can prepro-
gramme the kitchen timer with the most frequently used time periods. Up to
6 time periods can be preprogrammed. By default, the six memory slots are
preprogrammed with 5/10/15/20/25/30 minutes.
For the programming of the kitchen timer proceed as follows:
♦ Press the button Timer
activate the kitchen timer.
♦ Using the buttons
and the / Down-button
42
ning time for the kitchen timer. With each press on the button the start time
changes by one minute. Holding the button down for more than 2 seconds
starts the speed setting.
♦ Press the button Function / ST
remote control, to activate the kitchen timer. Next to the time display a blink-
ing is indicated, next to it appears a number for the fi rst timer.
♦ Using the buttons i / Pr+ / AL1
i
button or the
40
slot for the interval to be saved, between
Handling and operation
, or the button Timer
8
, or the button Timer
8
the cooking pot symbol and the backwards running
8 , or the button Timer
/ Up and i i / Down
17
on the remote control , set the desired run-
32
, or the button Function / ST
7
and i / Pr– / AL2
i
18
Pr– button on the remote control, select the memory
44
, or the button
8
on the remote
37
, or the button Timer
8
on the remote control,
37
on the remote control, to
37
, or the / Up- button
19
on the
38
, resp. the
16
and .
SKRI 2000 A1
37
Pr+